4 – 22
4.7 Clearing the Buffer Memory
This function deletes the data sent to the cutting plotter. It is used to abort cutting while it is in progress.
Press the (PAUSE) key to switch to PAUSE mode.
Stop the transmission of data from the computer if this is in progress.
Press the (NEXT) or (PREV.) key until the following menu is displayed.
Press the (ENTER) key to display the clear-buffer-memory menu.
Press the or key to select “YES” or “NO,” and then press the (ENTER)
key. To cancel the selection, select “NO” and press the (ENTER) key, or press
the (NEXT) or (PREV.) key.
Step
1
Step
2
Step
3
Step
4
Step
5
FEED
MOVE TO R. MARK
AUTO PRE FEED
TANGENTIAL
AUTO REG. MARK
CLEAR BUFFER
AXIS ALIGNMENT
DISTANCE ADJUST
PAGE LENGTH
PLOT AREA
EXPAND
ROTATE
MIRROR
COPY
SORT
RS-232C
COMMAND
BLADE WEAR SETUP
PEN UP/DOWN
TEST MODE
PEN UP SPEED
OFFSET FORCE
OFFSET ANGLE
STEP PASS
INIT. DOWN FORCE
LENGTH UNIT
CLEAR BUFFER
CLEAR <YES>
To Next Page
Loading...
