Need help?Do you have a question about the GRAPHTEC Craft ROBO CC100 and is the answer not in the manual?
Instructions on how to connect the AC adapter to the cutter and power outlet.
Steps for connecting the cutter to a computer using a USB cable.
Detailed procedure for loading media onto the Craft ROBO, including alignment.
Explains how blade adjustment caps control blade length for optimal cutting.
Provides a guide for selecting the correct blade adjustment cap based on media type.
Instructions on how to install the blade holder, including the use of the standoff ring.
Step-by-step guide on how to insert and secure a ballpoint pen into the holder.
Instructions for starting the installation process via the CD-ROM.
General instructions on how to start up the Craft ROBO Controller.
Provides two methods for launching the Craft ROBO Controller software.
Guide on performing test prints using a ball pen for design verification.
How to perform test cuts and adjust media settings for optimal cutting.
Steps for cutting designs without printing, using cutlines.
Process for printing designs with registration marks and then cutting them.
Details how to perform a test cut and interpret the results.
Explains the purpose and settings for registration marks in cutting printed designs.
Allows re-calibration of the registration mark sensor for accuracy.
To Next Page
General