GRAPHTEC Craft ROBO CC100 - If the system is unable to automatically read the registration marks

CHAPTER 3. CRAFT ROBO CONTROLLER
Position function. (The first registration mark is placed at the bottom left during the design stage and is
shown in green on the illustration in the Craft ROBO Controller.) (See 3.5.11-C Registration Mark
Reading.)
11. Press the [Registration mark reading] button. It starts reading of the registration marks. (See 3.5.11-C
Registration mark reading)
12. When registration marks are found, press [Cut]. It starts cutting operation. If registration mark reading
fails, reposition the media and return to Step 10.
3-10