GRAPHTEC Craft ROBO CC100 - Installing the ballpoint pen

CHAPTER 2. CONNECTION AND PREPARATION
Installing the ballpoint pen
Set a ballpoint pen into the ballpoint pen holder and then into the clamp bracket.
When attaching the ballpoint pen holder, always align it with the
notched part of the clamp bracket.
1. Loosen the thumbscrew by turning it counterclockwise.
2. Insert the ballpoint pen into the holder.
3. Confirm that the tip of the ballpoint pen protrudes from the holder 3 mm.
4. Tighten the thumbscrew by turning it clockwise.
5. Turn the lock lever to the left (OPEN direction)
6. Mount the ballpoint pen holder, making sure that the notched part of the holder
aligns with the opening of the clamp bracket.
Ballpoint pen
Loosen
Tighten
Thumbscrew
A
lign with the
notch.
7. Once the penholder is in place, turn the lock lever to the right (CLOSE direction).
2-12