CHAPTER 3. CRAFT ROBO CONTROLLER
3.4 Using the Craft ROBO Controller
Starting up the Craft ROBO Controller
Check to confirm that the LED lamp of the Craft ROBO is lit. If it is not, press the Standby switch.
Check to confirm that the Craft ROBO and your computer are connected by a USB cable.
Standby switch
LED lamp
The Craft ROBO Controller can be started up in either of the following two ways:
(1) Starting up from the Windows Start menu or the shortcut
The Craft ROBO Controller can be started up from the Windows Start menu.
To start it up, select
“Start”
Æ
“(All) Programs”
Æ
“Craft ROBO”
Æ
“Craft ROBO Controller”,
assuming that program group name is “Craft ROBO”.
The Craft ROBO Controller can be also started up from the shortcut that is placed on the desktop.
3-5
To Next Page
Loading...
