GRAPHTEC Craft ROBO CC100 - Setting the Blade Length; Blade holder description

CHAPTER 2. CONNECTION AND PREPARATION
2.4 Setting the Blade Length
Blade adjustment cap controls the blade length. To obtain better cutting results, select the blade adjustment cap
of the blade holder according to the type of media to be cut.
The length of the blade protruding from the cap should not exceed the
thickness of the media, otherwise the cutting mat may be damaged.
Caution
When handling the cutter blade, exercise care to prevent injuring your hand.
Blade holder description
The length of the blade protruding from the cap can be adjusted by selecting one of
the three available blade adjustment caps.
Select the blade adjustment cap best suited for the media in use. Always perform a
test cut to assure proper blade length.
Blade adjustment cap
Blue: Thin film
Yellow: Thick film, thin paper
Red: Thick paper such as a postcard
Blade holder
Blade
2-8