GRAPHTEC CC330-20 Craft ROBO User Manual

PREFACE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
USER’S MANUAL
MANUAL NO. CC300m-UM-151
CC300-20/CC330-20
CC300m-UM-151

GRAPHTEC CC330-20 Craft ROBO Specifications

General

Model	CC330-20
Blade Type	Supersteel Blade
Category	Plotter
Cutting Width	330 mm
Max Cutting Speed	100 mm/s
Connectivity	USB
Software Compatibility	CorelDRAW
Cutting Area	330 mm x 1000 mm
Resolution	0.1 mm
Power Supply	AC 100-240V, 50/60Hz
Supported OS	Windows

Summary

Chapter 1: Before You Start - Prior to Use

Control Panel Interface Guide

Chapter 2: Connecting and Preparing the Craft ROBO

2.1 Power Connection and Turn-On

Steps for connecting the AC adapter and power cable, and turning on the device.

2.2 Connecting to a Computer

Instructions for connecting the Craft ROBO to a computer using the USB cable.

2.3 Loading Media Using the Carrier Sheet

2.4 Loading Media Without Carrier Sheet (CC330-20)

2.5 Blade Adjustment and Plunger Mounting

Guide to adjusting blade depth, mounting the blade plunger, and selecting blade caps.

Chapter 3: Craft ROBO Controller Software Operations

3.2 Installing the Craft ROBO Controller

Detailed steps for installing the Craft ROBO Controller software and its driver.

3.3 Starting Up the Craft ROBO Controller

3.4 Craft ROBO Controller Operations

Guides through main operations: cutting designs, test plotting, and printing with registration marks.

3.5 Craft ROBO Controller Settings

Configuration options for media type, blade settings, speed, thickness, test cuts, and adding custom media.

Registration Marks and Calibration Procedures

Instructions for setting up and calibrating registration marks for accurate cutting.

Chapter 4: Cutting Data from SD Card

4.2 SD Card Cutting Operations