GRAPHTEC CC330-20 Craft ROBO - Control Panel Interface Guide

CHAPTER 1. PRIOR TO USE 1-3
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
Control Panel
This section explains the function of lamps and keys on the control panel.

Screen (LCD)
[SHIFT]
[ENTER]
Standby switch
LED lamp
Screen (LCD) ............................Displays the menu.

...........................................
Moves the tool carriage and media when <Start Point> is displayed on the
screen, and selects the menu item or sets the value during menu operation.
[ENTER] ....................................Enters the selected menu or defines the setting. In the Test Cut screen,
which is displayed only when the SD card is set in the SD card slot, press
[ENTER] while holding down [SHIFT] to perform a test cut.
Standby switch ........................Sets the Craft ROBO in and out of the standby status.
LED lamp ..................................Lights green when the Craft ROBO is in standby status.
[SHIFT] ......................................When <Start Point> is displayed on the screen, press

while holding down
[SHIFT] to feed the media toward the front of the main unit, or press

while
holding down [SHIFT] to feed the media toward the back of the main unit.
To perform a test cut, press [ENTER] while holding down [SHIFT], when the
Test Cut screen is displayed.
CHECKPOINT
You can operate the control panel keys only when the Craft ROBO is in standby status.