GRAPHTEC CC330-20 Craft ROBO - 2.3 Loading Media Using the Carrier Sheet

CHAPTER 2. CONNECTION AND PREPARATION 2-3
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
2.3 Loading Media Using the Carrier Sheet
CHECKPOINT
In this manual, the term "media" refers to paper, lm, and other materials to be cut or printed on.
About the carrier sheet
The carrier sheet allows you to cut media smaller than 210 mm x 305 mm, and cut right through the
media.
CHECKPOINT
For the CC300-20, be sure to use the carrier sheet at all times.
For the CC330-20, be sure to use the carrier sheet when cutting right through the
media, or when cutting the media without a backing sheet (linear).
The carrier sheet is reusable, and so it can be used repeatedly. When its adhesive
power becomes weak, however, replace it with a new carrier sheet.
The carrier sheet is a consumable. Replace it after cutting approximately 10 sheets.
Using a carrier sheet for more than 10 sheets may cause misaligned cutting or other
problems. Be sure to replace it with a new carrier sheet after cutting 10 sheets.
Pulling the carrier sheet out of the Craft ROBO may shorten its lifetime or cause
misaligned cutting. Be sure to select <Unload Media> menu on the control panel and
press [ENTER] to remove the carrier sheet.
The meshes printed on the carrier sheet allows you to check the media size. You can
also display the meshes of the carrier sheet on the ROBO Master screen to conrm the
cutting area. For further details, please refer to the ROBO Master User’s Manual.
Remove copying or ink-jet printing paper from the carrier sheet carefully. Pulling off the
paper roughly may tear the paper or leave pieces of paper on the carrier sheet.
•
•
•
•
•
•
•
Attaching media onto the carrier sheet
Using the carrier sheet for media with a width of 190 mm or smaller
CHECKPOINT
Do not use media smaller than postcard size.
(1) Peel off only the inside liner (off-white) of the carrier sheet, so that the adhesive surface is
visible. (Do not peel off the liner strips on both sides.)
Liner
Peel off only the inside liner.
(2) Press the media onto the adhesive surface of the carrier sheet.
When cutting horizontal images, t the lower-left corner of the media to the
 mark at the
upper-left corner of the carrier sheet.
When cutting vertical images, t the upper-right corner of the media to the
 mark at the
upper-right corner of the carrier sheet.