GRAPHTEC CC330-20 Craft ROBO - Test.plotting

I-2 INDEX
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER CH 4. CUTTING DATA SAVED ON SD CARD APPENDIX A INDEX
Setup Instruction Sheet ........................................... 1-1
Standard Specifications ...........................................A-1
Standby switch......................................................... 1-3
Starting up the installer ............................................ 3-1
T
Test Cut ................................................................. 3-12
Test Plotting ............................................................. 3-9
Thickness .............................................................. 3-11
Tool carriage ............................................................ 1-2
Tool holder ............................................................... 1-2
Track Enhancing .................................................... 3-11
U
USB cable ................................................................ 1-1
USB interface connector .......................................... 1-2
W
Warning ....................................................................... i
What to Do if This Happens ................................... 2-17