1-2 CHAPTER 1. PRIOR TO USE
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER
CH 4. CUTTING DATA SAVED ON SD CARD
APPENDIX A INDEX
1.2 Craft ROBO Parts and Functions
Main Unit
Push roller
Media rollers
Tool holder
Tool carriage
Front guide
AC adapter jack
USB interface connector
Guideline
Cutting mat
Control panel
SD card slot
Cap stockers
Top cover
Top cover..................................Open this cover when setting the tool or media. Be sure to close it during
cutting.
Tool carriage ............................Drives the tool holder to the left or right.
Push rollers ..............................Holds the media in place against the media rollers.
Tool holder ...............................Holds the tool and drives it up or down.
Cap stockers ............................Used to place the blade adjustment caps that are not used.
Guideline ..................................Used as a guide when media is loaded.
Front guide ...............................Used as the work surface.
Media rollers ............................Moves the media back and forth.
Cutting mat ..............................Cutting or plotting is performed on this surface.
Control panel ...........................Used to operate the Craft ROBO when cutting data saved on an SD memory
card.
AC adapter jack .......................Used for connecting the AC adapter cable.
USB interface connector ........Used for connecting the USB cable.
SD card slot .............................Insert an SD card.
To Next Page
Loading...
