GRAPHTEC CC330-20 Craft ROBO - Mounting.the.ballpoint.pen

2-16 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER CH 4. CUTTING DATA SAVED ON SD CARD APPENDIX A INDEX
Mounting the ballpoint pen
Mount a ballpoint pen into the ballpoint pen plunger and then mount the ballpoint pen plunger in the
Craft ROBO’s tool holder.
CHECKPOINT
When mounting the ballpoint pen plunger, always align it with the notched part of the tool
holder.
(1) Loosen the thumbscrew on the ballpoint pen plunger by turning it counterclockwise.
(2) Insert the ballpoint pen into the plunger.
(3) Conrm that the tip of the ballpoint pen protrudes 3 - 3.5 mm from the plunger.
(4) Tighten the thumbscrew by turning it clockwise.
(5) Turn the lock lever to the left (OPEN direction) to loosen the tool holder.
(6) Mount the ballpoint pen plunger in the tool holder while making sure that the protrusion on the
plunger faces the front and that it is aligned with the notch in the tool holder.
Loosen
Ballpoint pen
plunger
Tighten
Align with
the notch.
Ballpoint pen
Thumb
screw
(7) When the pen plunger has been mounted, turn the lock lever to the right (CLOSE direction) to
tighten it.