GRAPHTEC CC330-20 Craft ROBO - Allowable.cutting.area.of.the.carrier.sheet

2-4 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER CH 4. CUTTING DATA SAVED ON SD CARD APPENDIX A INDEX
CHECKPOINT
When pressing the media onto the adhesive surface, be careful not to cause air
bubbles or wrinkles in the media.
Make sure that the edges of the media are parallel to the meshes of the carrier
sheet.
•
•
Media
Carrier sheet
Adhesive surface
When cutting horizontal images,
t lower-left corner of the media
to the  (black triangle) mark at
the upper-left corner of the carrier
sheet.
When cutting vertical images, t
upper-right corner of the media to the
 (white triangle) mark at the upper-
right corner of the carrier sheet.
Using the carrier sheet for media from 191 to 270 mm in width (equivalent to A4 size)
CHECKPOINT
You can set media up to 270 mm in width. However, the allowable cutting area is the
same as that of the carrier sheet. (Please see "Allowable cutting area of the carrier
sheet.")
(1) Peel off the inside liner and the liner strips on both sides of the carrier sheet, so that the entire
adhesive surface is visible.
Liner
Peel off the inside liner and the liner strips
on both sides of the carrier sheet.
(2) Press the media onto the adhesive surface of the carrier sheet.
Fit the media to the outside frame of the meshes on the carrier sheet.
CHECKPOINT
When pressing the media onto the adhesive surface, be careful not to cause air
bubbles or wrinkles in the media.
Make sure that all of the media is pressed down.
Make sure that the edges of the media are parallel to the meshes of the carrier
sheet.
•
•
•