CHAPTER 2. CONNECTION AND PREPARATION 2-5
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A
CH 4. CUTTING DATA SAVED ON SD CARD
CH 3. CRAFT ROBO CONTROLLER
Media
Carrier sheet
Adhesive surface
210 mm
Fit the media to the outside frame of
the meshes on the carrier sheet.
305 mm
Loading the carrier sheet with media attached
When using media smaller than 210 mm x 305 mm, always afx the media within the allowable
cutting area.
Do not use media smaller than postcard size.
For details about the allowable cutting area of the carrier sheet, please refer to
"Allowable cutting area of the carrier sheet."
•
•
(1) Press the standby switch and conrm that the LED lamp is lit (green).
(2) Load the carrier sheet with media attached in the Craft ROBO.
Align the left edge of the sheet with the left guideline on the front guide. Place the top edge of
the sheet against both push rollers, making sure that the sheet is straight.
To Next Page
Loading...
