2-12 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER
CH 4. CUTTING DATA SAVED ON SD CARD
APPENDIX A INDEX
2.5 Adjusting and Mounting the Blade Plunger
The blade adjustment cap controls the blade length. To obtain optimum cutting results, select the blade
adjustment cap for the blade plunger to suit the type of media to be cut.
When handling the cutter blade, take care not to cut your hands.
Blade plunger construction
The blade plunger consists of a plunger to which a cap containing a blade is attached. The length
of the blade protruding from the cap can be adjusted by selecting one of the three available blade
adjustment caps.
Select the blade adjustment cap best suited for the media you plan to use.
Plunger
Blade adjustment cap
• Blue: Thin media, thin paper or lm
• Yellow: Medium thick paper such as Kent paper, thick lm
• Red: Thick paper such as scrapbooking paper
Blade
Blade adjustment caps and media selection
Select and attach the blade adjustment cap best suited to the media you plan to use. To prevent
damage to the cutting mat, the length of the blade protruding from the cap should not exceed the
thickness of the media.
When handling the cutter blade, take care not to cut your hands.
Selection guide for blade adjustment caps
Cap Media Protruding blade length
(approx.)
Blue Thin media, thin paper or lm 0.1 mm
Yellow Medium thick paper such as Kent paper, thick lm 0.2 mm
Red Thick paper such as scrapbooking paper 0.3 mm
To Next Page
Loading...
