CHAPTER 2. CONNECTION AND PREPARATION 2-15
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A
CH 4. CUTTING DATA SAVED ON SD CARD
CH 3. CRAFT ROBO CONTROLLER
2.6 Mounting a ballpoint pen
To mount a ballpoint pen, it is necessary to attach a ballpoint pen plunger (not supplied).
Acceptable ballpoint pens
The ballpoint pen plunger accepts the following pen types:
(1) Cylindrical ballpoint pens: Up to 8.5 mm in diameter
(2) Hexagonal ballpoint pens: Up to 7.5 mm side-to-side
(3) The tips of both pen types must extend between 3 to 3.5 mm past the ballpoint pen plunger
’s
opening.
Ø 8.5 mm
Cylindrical
ballpoint pen
7.5 mm
Thumb screw
3 to 3.5 mm
Pen tip
Ballpoint
pen plunger
To Next Page
Loading...
