2-14 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER
CH 4. CUTTING DATA SAVED ON SD CARD
APPENDIX A INDEX
Mounting the blade plunger
Mount the blade plunger that has had its protruding blade length adjusted (by selecting the most
suitable blade adjustment cap) in the Craft ROBO.
When handling the cutter blade, take care not to cut your hands.
Be sure to grip the tool holder rmly when mounting or removing the blade plunger.
(1) Turn the lock lever to the left (OPEN direction) to loosen the tool holder.
Tighten
Lock lever
Loosen
(2) Firmly insert the blade plunger in the tool holder and then turn the lock lever to the right
(CLOSE direction) to tighten the tool holder.
Plunger
Tool holder
Firmly insert the blade plunger until the underside
of the ange contacts the tool holder.
Front
To Next Page
Loading...
