GRAPHTEC CC330-20 Craft ROBO - Chapter 1: Before You Start - Prior to Use

CHAPTER 1. PRIOR TO USE 1-1
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A CH 4. CUTTING DATA SAVED ON SD CARD CH 3. CRAFT ROBO CONTROLLER
CHAPTER 1. PRIOR TO USE
1.1 Check All the Items
Referring to the list below, check to conrm that all the components are included with your product. If any
item is missing, please contact your place of purchase.
AC adapter, Power cable ....1 set
Craft ROBO Software CD-ROM ....1
Quick Application Guide ....1
Blade plunger (with blade adjustment caps) ....1 set
USB cable ....1
Setup Instruction Sheet ....1
Carrier sheet ....1
Note: One of the blade adjustment
caps is attached to the blade
plunger.
Blade adjustment caps
(blue, yellow and red)