Contents iii
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A
CH 4. CUTTING DATA SAVED ON SD CARD
CH 3. CRAFT ROBO CONTROLLER
3.5 Craft ROBO Controller Settings ...............................................................................................3-10
3.6 Error Messages .........................................................................................................................3-18
CHAPTER 4. CUTTING DATA SAVED ON SD CARD
4.1 Introduction .................................................................................................................................4-1
4.2 Operations ...................................................................................................................................4-1
Cutting with the tool conditions set in the previous cutting ..................................................4-2
Cutting with new tool conditions ...............................................................................................4-3
Cutting the same image repeatedly (Copy) ..............................................................................4-5
Changing the LCD language ......................................................................................................4-7
4.3 Error Messages ...........................................................................................................................4-7
APPENDIX
Appendix A. Standard Speciļ¬cations ................................................................................................. A-1
INDEX ..........................................................................................................................................................I-1
To Next Page
Loading...
