2-2 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER
CH 4. CUTTING DATA SAVED ON SD CARD
APPENDIX A INDEX
2.2 Connecting to a Computer
Use the USB cable provided with the Craft ROBO to connect the Craft ROBO to a computer.
Install the software for the Craft ROBO before connecting the Craft ROBO to a computer.
(See Chapter 3.2, "Installing the Craft ROBO Controller".)
Do not connect the USB cable until instructed to do by an on-screen prompt.
•
•
The USB cable has different plug shapes on the computer side and the Craft ROBO side. Always
check which plug connects to which side.
Do not connect two or more Craft ROBO units to one computer.
Do not connect the Craft ROBO and a Graphtec plotter to a computer at the same time.
If you do so, the Craft ROBO may not operate properly.
•
•
To Next Page
Loading...
