2-6 CHAPTER 2. CONNECTION AND PREPARATION
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
CH 3. CRAFT ROBO CONTROLLER
CH 4. CUTTING DATA SAVED ON SD CARD
APPENDIX A INDEX
Place the top edge of the carrier sheet against both push rollers.
To ensure that the loaded
sheet is straight, align the left
edge of the sheet with the left
guideline on the front guide.
Left guideline on the
front guide
(3) Make sure that <Load w/ Carrier> is displayed on the screen of the control panel, and press
[ENTER].
For the CC330-20, press or on the control panel to select <Load w/ Carrier>,
and press [ENTER].
Load w/
Carrier
Unload
Media
Select
File
When the SD card is not set in the SD card slot
When the SD card is set in the SD card slot
The Craft ROBO feeds the carrier sheet automatically.
To Next Page
Loading...
