CHAPTER 2. CONNECTION AND PREPARATION 2-7
PREFACE
CH 3. CRAFT ROBO CONTROLLER
CH 1. PRIOR TO USE
APPENDIX A
CH 2. CONNECTION AND PREPARATION
INDEX
CONTENTS
CH 4. CUTTING DATA SAVED ON SD CARD
PREFACE CONTENTS CH 1. PRIOR TO USE
CH 2. CONNECTION AND PREPARATION
INDEXAPPENDIX A
CH 4. CUTTING DATA SAVED ON SD CARD
CH 3. CRAFT ROBO CONTROLLER
How to unload the carrier sheet
Press to select <Unload Media>, and press [ENTER].
Unload
Media
Load w/
Carrier
The carrier sheet is output toward the front of the main unit.
When cutting is nished, <Unload Media> is displayed on the screen. In this case, just
press [ENTER] to unload media.
Allowable cutting area of the carrier sheet
Make sure that your design ts within the allowable cutting area indicated below.
Set the arrow faced toward
Craft ROBO main unit.
190mm
Allowable cutting area
10mm
Standard mode
200mm
305mm
10mm
5mm 5mm
305mm Allowable cutting area
Expanded mode
Follow the procedure below to change the mode from Standard to Expanded or vice versa. The
default setting is "Standard" mode.
1. In the Control Panel, open "Printers" ("Printers and Faxes" for Windows XP).
2. Open "Properties" for Graphtec CC300 or CC330.
3. Click [Printing Preferences] in the "General" tab.
4. Select the desired mode in "Margins" on the "Basic Setup" tab.
(If you create the cut data using the ROBO Master or Cutting Master 2, the [Expanded] mode is
selected.)
• The allowable cutting area indicated above is applicable only when the media is set correctly.
•
To Next Page
Loading...
