CHAPTER 2. CONNECTION AND PREPARATION
Installing the blade holder
Insert the blade holder that has had its protruding blade length adjusted into the
cutter.
Caution
When handling the cutter blade, exercise care to prevent injury.
When using the carrier sheet, use the standoff ring included with the
Craft ROBO.
Hold the clamp bracket tightly while attaching or removing the blade
holder.
1. Turn the lock lever to the left (OPEN direction) and remove the blade holder.
Firmly insert the blade holder in place
until this face contacts the holder.
Lock lever
2. When using the carrier sheet, always use the standoff ring included with the
Craft ROBO. Standoff ring compensates for the blade depth when using the
carrier sheet. Attach the standoff ring to the blade holder before setting the blade
holder in place.
Standoff ring
ttach the Standoff ring to the cutter
pen, and firmly insert it in place.
3. Insert the blade holder in the clamp bracket and turn the lock lever to the right
(CLOSE direction).
2-10
To Next Page
Loading...
