GRAPHTEC Craft ROBO CC100 - Blade adjustment caps and media selection; Changing the blade adjustment caps

CHAPTER 2. CONNECTION AND PREPARATION
Blade adjustment caps and media selection
Select and set the blade adjustment cap best suited to the media in use
Selection guide for blade adjustment caps
Cap Media
Blue Thin film
Yellow Thick film, thin media
Red Thick media
Changing the blade adjustment caps
The blade adjustment cap is a screw-on type.
Blade holder
Blade
adjustment cap
1. Turn it in the counterclockwise direction to remove the cap.
2. Replace with the correct blade adjustment cap.
3. Turn it in the clockwise direction to tighten the cap.
Loosen
Tighten
Blade holder
Blade adjustment cap
2-9