CHAPTER 3. CRAFT ROBO CONTROLLER
3.5.11-C Registration Mark Reading
This is displayed when Search Registration Marks is turned off.
It starts manual reading of the registration marks.
(2) After performing Step (1), click
on the [Registration Mark
Reading] button. It starts manual
reading of the registration marks.
(1) Use the [Blade Position] button to move the
blade to within the range of the registration
mark.
The range of the registration mark is displayed
as a green rectangle in the illustration at the
upper right corner of the Controller. The range
of the registration mark position may change
based on the orientation of the design.
Note: When the registration marks have been read, it becomes impossible to operate the [Registration
Marks] group box and [Design Orientation]. In addition, the [Calibration] button is disabled.
To enable operation again, turn the Standby switch of the Craft ROBO off, then on again.
3-19
To Next Page
Loading...
