3
To Ensure Safe and Correct Use
1
WARNING
Safety Precautions
During a cutting or plotting operation, do not
touch the writing panel or moving parts such
as the carriage.
• Such action may cause human injury.
Do not disassemble, repair, or remodel the
Craft ROBO.
• Such action may cause electrical shock or a fire
hazard due to current leakage.
• Contact with the high-voltage parts within the
Craft ROBO may cause electrical shock.
• If the Craft ROBO requires repair, contact your
sales representative or nearest Graphtec
vendor.
Keep your hands, hair, etc. away from the
writing panel and moving parts such as the
carriage even if the Craft ROBO is stopped,
because it may suddenly start moving when
data is received.
• Such action may cause human injury.
Do not connect the Craft ROBO to a
non-rated power supply.
• Use of a different supply voltage may result in
electrical shock or a fire hazard due to current
leakage.
Do not allow dust or metallic matter to adhere
to the power plug.
• A dirty power plug may result in electrical shock
or a fire hazard due to current leakage.
Do not use the power cord or AC adapter if it
is damaged.
• Use of a damaged power cord or AC adapter
may result in electrical shock or a fire hazard
due to current leakage.
• Replace the power cord or AC adapter with a
new one.
Be careful when handling the blade, blade
holder.
• Touching the blade with your bare hand may
cause injury.
• During a cutting operation, keep away from the
blade, blade holder.
Only use the AC adapter that was supplied as
a standard accessory.
• Use of any other AC adapter may cause
malfunctions or result in electrical shock or a
fire hazard.
Do not use the Craft ROBO in a location
where it will be exposed to water, rain or
snow.
• Such location may cause electrical shock or a
fire hazard due to current leakage.
If the Craft ROBO generates smoke,
is too hot, emits a strange odor, or
otherwise functions abnormally, do not
continue using it. Unplug the AC adapter’s
power cord from the electrical socket.
• Use of the Craft ROBO in such status may result in a fire
hazard or electrical shock.
• After confirming that smoke is no longer being generated,
contact your sales representative or nearest Graphtec vendor
to request repair.
• Never try to perform
repair yourself.
Repair work by
inexperienced personnel
is extremely dangerous.
Do not touch
Keep your distance
No disassembly
Prohibited
Prohibited
Avoid water
Beware of electrical shock
Rated
power
supply
Unplug the power
cord from the socket
Prohibited
Prohibited
Beware of electrical shock
Avoid contact
To Next Page
Loading...
