GRAPHTEC midi LOGGER GL220 - Connecting the Humidity Sensor (Option)

2-14
CHAPTER 2 Checks and Preparation
2.10 Connecting the Humidity Sensor (Option)
Connect the + and - lead wires of the humidity sensor (the B-530 option) to the desired terminals, and
theninsert the round connector into the 5V OUT connector on the GL220.
Do not use the sensor in a strong electrolyte envronment. Measured results may not satisfy to the stated.
Humidity sensor
(the B-530 Option)
Connected to the
5V OUT terminal.
Brown: Connected to the + terminal
White: Connected to the - terminal