GRAPHTEC midi LOGGER GL220 - Configuration Menu Navigation

3−16
CHAPTER 3 Settings and Measurement
3.4 Setting Menus
When you press the MENU key during Free Running, the following menu screens appear.
The menu screens are classified by the tab for each setting item.
AMP DA T A TRIG USER OTHR
(1) AMP settings
This menu is used to specify input signal-related settings.
<Analog settings> <Logic Pulse settings>
Setting Selections available
Input Off, Voltage, Temperature, Humidity
Range [Voltage] 20, 50, 100, 200, 500 mV; 1, 2, 5, 10, 20, 50, 1-5 V
[Temperature] TC-K, TC-J, TC-T, TC-R, TC-E, TC-B, TC-S, TC-N, TC-W
Filter Off, 2, 5, 10, 20, 40
EU
(Scaling
settings)
Function Off, On
Meas.
Value
Upper limit Set numeric value
Lower limit Set numeric value
EU output
value
Upper limit Set numeric value
Lower limit Set numeric value
Dec pt EU output upper limit x 1, x 10, x 100, x 1000
Select Current,length,area,volume,speed,acceleration,frequency,weight,
work, pressure, flow rate, temperature
Choose (The selections vary depending on the unit selected in the above.)
Arbitrary unit Text input
Misc.
Inter-CH
Op Settings
Function Off, On
Operation CH-X (+, -, x, /) CH-Y
Scaling /1000000, /1000, ×1, ×1000, ×1000000
Upper/Lower limit Set numeric value
Dec pt ×1, ×10, ×100, ×1000, ×10000
Select Current,length,area,volume,speed,acceleration,frequency,weight,
work, pressure, flow rate, temperature
Choose (The selections vary depending on the unit selected in the above.)
Arbitrary unit Text input
Span set-
tings
Upper limit Set numeric value
Lower limit Set numeric value
Annotation string Text input (Max. 31 characters)
Waveform color setting 0 to 31 for each of red, green, blue (RGB)
Amplitude Setting 1 to 8 dots
Perform Auto Zero ADJ.
Press right key to execute.
Reset Auto Zero ADJ.
Press right key to execute.
Logic/Pulse Off, Logic, Pulse
[Logic] Filter Off, On
Misc. Waveform color
setting
0 to 31 for each of red, green, blue (RGB)
[Pulse] Input Off, Revolution counts, Counts, Inst.
Filter Off, On
Slope
↑
H,
↓
L
EU Function Off, On
Meas. Value Set numeric value
EU output value Set numeric value
Select Current,length,area,volume,speed,acceleration,frequency,weight,
work, pressure, flow rate, temperature
Choose (The selections vary depending on the unit selected in the above.)
Arbitrary unit Text input
Misc Waveform color
setting
0 to 31 for each of red, green, blue (RGB)
Amplitude Setting 1 to 8 dots