II
Introduction
(7) Insofar as possible, position the GL220 input signal cables away from any other cables which are likely to be
affected by electromagnetic interference.
(8) For stabilized measurement, allow the GL220 to warm up for at least 30 minutes after turning it on.
About Registered Trademarks
• MicrosoftandWindowsareregisteredtrademarksortrademarksofMicrosoftCorporationintheU.S.and
elsewhere.
• Othercompanynamesandproductnamesincludedinthismanualareregisteredtrademarksortrademarksof
their respective companies.
To Next Page
Loading...