3−33
CHAPTER 3 Settings and Measurement
(4)-1 USER settings
Setting Description
User Specify the user name. You cannot specify it as Guest.
Department name Specify the department name. You cannot specify it as Guest.
Setting conditions
switch
Switches between Guest, User1 and User2.
Since setting conditions are stored for each user, they can be
called up easily by simply switching the user.
(4)-2 About the Macro
Interface commands for GL220 can be described in a text file and read in. GL220 will operate asdescribed
in this file.
<Macro operation flow>
Select the macro file and run the file.
▪ Macro file name:
▪ Execute Macro:
GL220 executes the commands
as described in the macro file.
Create a macro file using a text editor on your PC
(save the file with extension "GMA").
Copy this file to a USB memory , and then connect
the USB memory to GL220.
Macro description example (file name: xxx.GMA)
Refer to the “Interface Command Table” for details on commands supported by GL220 on a separatesheet.
The “Interface Command Table” is included in the CD. (Library folder GL220_820_IF_Command.PDF)
Supported commands are limited to those relative to GL220 settings.
Read in commands cannot be used.
To Next Page
Loading...
