GRAPHTEC midi LOGGER GL220 - Page 76

3−44
CHAPTER 3 Settings and Measurement
(9) Data replay menu
Data replay menus are displayed by pressing the MENU key during replay.
Setting Selections available
Cursor
Position
Move to First Data
Press right key to execute.
Move to Last Data
Press right key to execute.
Move to Center
Press right key to execute.
Move to
Selected Posi-
tion
Method: Position, Time
[Position] Position 0 to end of data
For example, if the sampling interval is 100 ms, capture desti-
nation is the internal memory, and the number of data points
is 10000, settings up to 99.9 s are available.
[Time] Date Date from the start to end of the data
Time Time from the start to end of the data
Cursor Synch Off, On
Data search CH CH1 to 10, Logic, Pulse, Alarm
* Logic and Pulse are displayed only if the Logic Pulse func-
tion is On in the AMP settings.
[CH1 to CH10] CH1-10
[Logic] Logic1-4
[Pulse] Pulse1-4
[Alarm] Alarm1-4
Mode [CH1 to CH10]
↑H, ↓L
[Logic]
↑H, ↓L
[Pulse]
↑H, ↓L
[Alarm]
Both, ↑H, ↓L
Level [CH1 to CH10] Set numeric value
Set numeric value
Find Next
Press right key to execute.
Find Previous
Press right key to execute.
Statistical
calculation
between
cursors
Function Off, Average, Max, Min, Peak, RMS
Execute
Press right key to execute.
(9)-1 Move to First Data
Executing this option moves the currently selected cursor (A or B) to the start of the data.
(9)-2 Move to Last Data
Executing this option moves the currently selected cursor (A or B) to the end of the data.
(9)-3 Move to Center
Executing this option moves the currently selected cursor (A or B) to the center of the data.