EasyManua.ls Logo

GRAPHTEC SK200-09 - Jam Removal and Calibration

GRAPHTEC SK200-09
57 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4-6
4.6 Removing a Jammed Document
If a document becomes jammed in the scanner during scanning or another operation, follow the
procedure described below to remove the jammed document.
(1) Turn off the scanner.
(2) Open the top cover as described in Section 4.1 “Opening and Closing the Top Cover”.
(3) If the document is jammed at the front, remove the document by pulling it forward.
(4) If the document is jammed at the rear, remove the document by pulling it out along the
rear guides.
Rear guides
(5) Close the top cover as described in Section 4.1, “Opening and Closing the Top Cover”.
Caution
•Take care not to get your fingers caught in the top cover.
When removing a jammed document, pull on it gently to prevent damage to the
document.

Table of Contents

Other manuals for GRAPHTEC SK200-09

Related product manuals