GRAPHTEC Yamato GL240 - Interface Settings; Usb Settings

3-54
CHAPTER 3 Settings and Measurement
(4) Interface settings
This menu is used to specify conditions for PC connection.
Setting Selections available
Selections availableNew Line code CR+LF, LF, CR
USB settings USB ID 0 to 9
(4)-1 New Line code
Species the line feed code.
Selection item Description
CR+LF Starts a new line with CR+LF code (default value).
LF Starts a new line with LF code.
CR Starts a new line with CR code.
(4)-2 USB settings
Sets the USB ID number of GL240.
Specify a number from 0 to 9 (default value: 0).
To control more than one GL240 unit with one PC, assign a unique USB ID to each of them.