GRAUPNER HEIM 3D 100 - Page 13

12 13
quick 2
acro 3D
4I
rotor direct
swashplate
right
cut off +150%
pitch min rear
autorotat.
5I
1 servo
–100% 1
In the line “Throttle Cut”, leave the default but assign switch S1 as shown in the gure to the top right by moving the
switch from front to rear after activating the switch assignment.
Then bind the receiver to the transmitter as described in the transmitter instructions. Leave the defaults in the menu
“Servo” menu. Switch to the menu “Heli Mixer”, and set the option “Pitch” in all three phases as shown in the following
gures:
input
output
point
1
0%
–35%
–35%
pitch
normal
input
output
point
2
–50%
–70%
–70%
pitch
acro 3D
input
output
point
4
+50%
+70%
+70%
pitch
autorot.
Then switch to the option “CH1 => Throttle”, and set the individual values for the points as follows in Q.Links “Normal”
and Akro 3D”. Actuate the different throttle positions with the joystick as follows:
input
output
point
4
+50%
+90%
+90%
pitch
normal
thro
In the „Normal“ Q.Link, set point 2 at 25% throttle travel
to a value of 50%, point 3 at 50% travel to 75%, and
point 4 at 75% throttle travel to a value of 90% so that
the curve has the following appearance.
input
output
point
3
+50%
+95%
+95%
pitch
acro 3D
thro
In Q.Link „Akro 3D“, set point 1 at 0% throttle travel to
a value of 100%; point 2 at 25%, and point 4 at 75%
throttle travel to a value of 97%, and point 3 in the
middle to a value of 95% so that the curve has the fol-
lowing appearance.
tail
pitch
thro
Autorot
swash lim.
off
SEL
0%
–100%
gyro
0%
Perrform the other settings of „CH1 => Throttle“ in the
autorotation phase as well as the other settings accor-
ding to the instructions accompanying the transmitter,
helicopter and receiver GR-18.