16 17
Tail rotor setting
Tail sensitivity
Tail sensitivity: 1 – 10, MIN or K5 – K16
Default setting: 5
The „Tail sensitiv.“ row allows you to specify a sensitivity setting either using the values 1 to 10 or by assigning a
channel (K5 to K16) with a proportional control, which is used to control the value. Once you have found a satisfactory
setting, this value can be applied as a xed value by pressing the „right“ or „left“ button.
Different settings can then be used to adjust the sensitivity based on specic ight phases.
If the tail swings up, the corresponding value must be reduced.
TAIL ADJUST <v>
>Tail sensitiv. (5)K9
To Next Page
Loading...
