17 33700 SMART-BOX - Graupner HoTT 2.4
After a few seconds the Status screen displays the message “Found target device…” and the fi rmware
update process commences.
If the device is not recognised, if the pop-up window “Target device ID not found” appears, or if the process
fails before 100% is reached, you must restart the update procedure. Repeat all the steps as described
above.
The Status display and the Progress bar show the progress of the fi rmware update (B). The update is com-
pleted when the message “Download Process Complete“ or “Complete!!” appears (C).
Disconnect the USB interface cable and the power supply lead. Your SMART-BOX is ready to use.
B
C
To Next Page
Loading...