14 / 16
3974.32_MP_V1
Setting the Kingpad
A co-ordination between the Graupner / Kingpad mc Edition and
the Graupner central module must take place so that the perfect
function is guaranteed. Proceed as follows:
Make sure there is a connection between the remote control
and the receiver.
Connect the steering channel to the "Kingpad" input on the
Graupner central module!
Press the white Prog button on the Kingbus central module for
more than 2 seconds until the yellow LED flashes in a second
rhythm
Push the upper left button. As confirmation for a detected key,
the Prog-LED on the KBCM goes off and remains off when pres-
sed!
Release the button. The Prog-LED flashes again and the next key
can be read.
Press the individual keys one after the other; starting from top
left to right and then bottom left to right!
After the twelfth key (S), the flashing key must be pressed again.
This will cause the Kingbus central module to automatically exit
programming mode and return to normal mode.
The Kingpad is now set and it can be used
To Next Page
Loading...
Need help?
General
