GRAUPNER mc-32

144 Detail program description - Phase settings | Winged models
Example:
Phase 1
Phase 2
Phase 3
Phase 4
Phase 5
Name Timer
Sw. time
Motor
0.1s
yes
0.1s
yes
1.1s
yes
0.1s
yes
0.1s
–
–
–
–

Normal
Launch
Dist.
yes
The switchover time from any other phase to Phase 1
«normal» will take 2.2 s.
The time for a switchover from, for example, Phase 1
to Phase 3, is set to 1.1 s and the time for a switchover
from Phase 1 or 3 to Phase 2 "Launch" is 1.5 s.
Such asymmetric transition times can be useful when,
e.g. switching between extremely different fl ight
phases, such as between aerobatics and normal fl ight.
A simultaneous tap on the  or  keys of the
right touch pad (CLEAR) will reset the time in the
currently active value fi eld back to 0.1.
Note:
The "switch time" set here applies uniformly to all
settings that are specifi c to fl ight phases, and thus
to all mixers activated in the »Wing mixers« menu,
see page 160. Accordingly, the transition between
fl ight phase-specifi c mixers does not occur abruptly.
However, if individual servos are to be switched
without a delay then these can be defi ned accordingly
in the »Non-delayed chan« menu (see page 151).