107
Program description: Phase trim – fixed-wing model
P H A S E T R I M
normal
0%
0%
0%
takeoff
speed
thermal
0%
0%
0%
0%
0%
0%
0%
0%
0%
AIL ELEFLA
Select the desired control surface function using the
arrow buttons of the left or right-hand touch-key,
then briefly press the central SET button of the right-
hand touch-key. The trim values in the highlighted value
field can now be adjusted using the arrow-buttons of the
right-hand touch-key.
You can activate each phase by operating the assigned
phase select switch or switches. Note that the servos
do not change from one setting to another abruptly;
they move smoothly with a transition time of around one
second.
With this option, which works in a similar way to trans-
mitter control sub-trim or offset settings with other radio
control systems, it is possible to set values within the
range -99% to +99%. However, typical values are nor-
mally in single figures or low double figures.
normal 0%
0%
0%
+2%
4%
+8%
–3%
–5%
–7%
+2%
+5%
+10%
P H A S E T R I M
takeoff
speed
thermal
AIL ELEFLA
If you have made any changes, simultaneously pressing
the or buttons of the right-hand touch-key
(CLEAR) resets them to the default value of 0%.
Note:
In this menu you will have at least one control function
(ELE), and a maximum of three functions (ELE, AIL and
FLA), available for phase-specific trim settings, depend-
ing on the settings you have entered in the “Aileron /
flap” line of the “Base settings” menu (see page 77).
To Next Page
Loading...
