20
Description of transmitter
Description of transmitter
Front of transmitter
Aerial with folding / rotating base
Rotary proportional control CTRL 7
3-position switch SW 4/5
2-position momentary
switch SW 1
Rotary proportional
control CTRL 6
Left-hand stick
Trim
ON / OFF switch
Left-hand touch-button
LCD screen
Right-hand touch-button
Trim
Right-hand stick
2-position switch SW 3
Carry handle
Neckstrap lug
Attaching the transmitter neckstrap
You will find a strap lug mounted in the centre of the
front face of the mx-16 HoTT transmitter, as shown in
the drawing on the right. This lug is positioned in such a
way that the transmitter is perfectly balanced even when
suspended from a neckstrap.
Order No. 1121 Neckstrap, 20 mm wide
Order No. 70 Neckstrap, 30 mm wide
3-position switch SW 6/7
Rotary proportional control CTRL 8
Important note:
In the transmitter’s standard form any servos connected
to the receiver can initially only be operated using the
dual-axis sticks. For maximum flexibility, all the other
transmitter controls (CTRL 6 ... 8, SW 1 ... 9) are “free”
in software terms, and can be assigned to any channels
you like, enabling you to set up the system to suit your
personal preference or the requirements of a particular
model. This is carried out in the “contr set.” menu, as
described on pages 94 (fixed-wing models) and 96
(model helicopters).
2-position switch SW 2
2-position switch SW 8
2-position switch SW 9
Central Status LED
To Next Page
Loading...
