153
Program description: Telemetry menu
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
3
1
VARIO
7
… then briefly press the central SET button of the right-
hand four-way button to open the selected sub-menu:
VOLT:
MODELTIME:
BATTERYTIME:
RUNTIME:
STOPWATCH:
In this menu you can activate ( ) or disable ( ) the
chosen speech output after using the arrow buttons
of the left or right-hand four-way button to select
the desired line, followed by a brief press of the central
SET button of the right-hand four-way button:
VOLT:
MODELTIME:
BATTERYTIME:
RUNTIME:
STOPWATCH:
RECEIVER
Select the desired menu line with the arrow buttons
of the left or right-hand four-way button …
VOICE TRIGGER
REPEAT 10SEC
TRIG
TRANSMITTER
RECEIVER
3
1
VARIO
7
… then touch the central SET button of the right-hand
four-way button to call up the selected sub-menu:
TEMP:
STRENGTH:
VOLT:
LOWVOLT:
In this menu you can activate ( ) or disable ( ) the
chosen speech output after using the arrow buttons
of the left or right-hand four-way button to select
the desired line, followed by a brief press of the central
SET button of the right-hand four-way button:
TEMP:
STRENGTH:
VOLT:
LOWVOLT:
„Sensors“
These lines only appear if you previously activated at
least one sensor in the “SELECT SENSOR” sub-menu
of the “TELEMETRY” menu; see page 150. The cor-
responding voice outputs are selected using the proce-
dure described in the previous sections.
Note:
The selection you make here is completely independent
of the “VARIO” voice outputs.
To Next Page
Loading...
