GRAUPNER mx-16 HOTT - Page 33

33
Description of transmitter - Telemetry data display
SENSOR 1
0.0V
0°C
SENSOR 1
This display visualises the actual voltage and tempera-
ture measured by a temperature / voltage sensor, Order
No. 33612 or 33613, connected to the “T(EMP)1” socket
of the Electric Air module (Order No. 33620).
SENSOR 2
0.0V
0°C
SENSOR 2
This display visualises the actual voltage and tempera-
ture measured by a temperature / voltage sensor, Order
No. 33612 or 33613, connected to the “T(EMP)2” socket
of the Electric Air module (Order No. 33620).
Vario
0.0
0
m
m
s
This display visualises the data for altitude in m relative
to the location or launch point, and the actual climb /
sink rate in m/s, generated by the integral vario in the
Electric Air module (Order No. 33620).
VARIO
RECEIVER
GENERAL
ELECT. AIR
VARIO
GPS
RXSQ
0
MAX
0m
MIN
0m
ALT
0
H
L
m/1s
0.0
m/3s
0.0
m/10s
0.0
This display visualises the data from a Vario module,
Order No. 33601, connected to the receiver.
The meanings are as follows:
Value Explanation
ALT Current altitude
RXSQ Signal strength of the signal picked up
by the receiver in %
MAX The pre-set altitude limit relative to
the launch point; above this altitude
the transmitter emits audible warning
signals
MIN The pre-set altitude limit below the
launch point; below this altitude the
transmitter emits audible warning
signals
m/1s m/1 sec climb / descent
m/3s m/3 sec climb / descent
m/10s m/10 sec climb / descent
H High
L Low
Vario
0.0
0
m
m
s
This display visualises the data for altitude in m relative
to the location or launch point, and the actual climb /
sink rate in m/s, generated by a Vario module (Order No.
33601) connected to the Telemetry socket of a receiver.
GPS
RECEIVER
GENERAL
ELECT. AIR
VARIO
GPS