90
Program description: base settings - model helicopter
cur in a typical flight. To ensure safe operation of the
model, the range must always be at least fifty metres
on the ground.
Caution:
Never initiate a range-check when you are actually
operating a model!
RF transmit
In this menu line you can manually switch the transmit-
ter’s RF transmission on and off again for a specific
model for the period that the transmitter is currently
switched on. For example, you might wish to do this to
save power when demonstrating the programming of a
model. If you switch the transmitter off with the RF
module switched off, next time you switch the trans-
mitter on it will be switched back on again.
Use the arrow buttons of the left or right-hand
touch-key to move to the “RF transmit” line, and touch the
central SET button of the right-hand touch-key to activate
the value window:
autorotat.
2
receiv out
rx bind R08
range test
99sec
RF transmit
ON
Now you can use the right-hand arrow buttons to switch
between OFF and ON. Touch the central SET button of
the right-hand touch-key again to conclude the input.
To Next Page
Loading...
