13 / 19
3974_MP_V3
Programming of receiver and digital switches
For the transmitter to be able to transmit the data correctly, settings
must be made on the transmitter and receiver:
Enter the "Telemetry" menu of the transmitter, open the "Settings &
view" line and move through the touch pads to the "CH OUT TYPE"
line. Here please select the "SUMD3" mode.
This transmission mode is absolutely necessary for the use of the
module! To do this, the receiver must have the latest software ver-
sion. (from V7a..)
To assign the digital switches, call up the menu in the transmitter:
Depending on the transmitter, 16-64 digital switches are available
here.
mz-16: 16 digital switches
mz-32 : 64 difital switches
mc-16 Expert: 16 digital switches
mc-32 Expert: 64 digital switches
1. The switch is activated via menu item "Act". By tapping the plug
symbol is closed. Now it is active.
(As an example, the screenshot above renamed the first two switches.
This name will appear later on the display with the switch symbol.)
Switch active
Switch inactive
To Next Page
Loading...
Need help?
General
