15
Reverse function ...R speed controller
Important:
These speed controllers feature a fully proportional brake and a
fully proportional reverse function.
To select reverse you have different possibilities:
2. Reverse at motor stop:
Your car must stop and you move the stick to "neutral”, now you
can run in reverse with proportional speed control.
To stop the car move the stick to “full brake”, if necessary.
3. After the adjusted time the brake will switch to the reverse
function. (Time to reverse: 0 - about 5 seconds)
Possibility 1 can be combined with possibility 2 and/or 3.
See programming the additional functions #5 and #6 at the
following pages.
Please note that you must not connect a Schottky diode to the
motor if you are using a reversing controller. If you do, the speed
controller will be wrecked the moment you switch to reverse.
1.To switch to reverse function, move your transmitter stick to full
brake and next to neutral. Now you can run in reverse with
proportional speed control.
To Next Page
Loading...
Need help?
General
