www.modellmarkt24.ch; www.modellmarkt24.de
9 / 16
S1031_HB_V1
Transmitter power supply
Installing transmitter batteries
Remove the battery case cover on the back side of the transmitter.
Insert the battery according to the correct polarity. (See figure in
the battery case)
Removing transmitter batteries
If the transmitter is not going to be used for a long time, the
batteries or accumulators must be removed from the device.
Therefore you can avoid damages to the transmitter due to
electrolyte leaks.
Preparation before use
The mz-4 HoTT transmitter is normally delivered with three AAA
type alkaline batteries.
The transmitter battery voltage is monitored by the red status
LED (2) during operation.
If the voltage drops below 3,5 V, an acoustic alarm (4x higher
signal tones) will sound and the red status LED (2) starts to blink
quickly. Stop immediately the use of the transmitter, batteries
must be changed.
Binding the receiver
If you want to bind a receiver with the mz-4 HoTT transmitter,
bring the receiver in the bind mode (follow receiver's manual),
then push the "CUT OFF/ BIND" button (5) on the transmitter.
If a receiver is already bound to a model memory and you
however want to bind a new receiver to the model memory, then
you will need to repeat the binding process twice.
The first process erases the previous receiver, the second
process stores the new receiver.
Binding the Vector Unit GRS 331
1. Switch the Vector Unit on
2. Push on the "CUT OFF/ BIND" (5) button on the transmitter
Successful binding process
If the binding process was successful the status LED (2) will light
red on the transmitter.
Unsuccessful binding process
If the binding process was not successful the status LED (2) will
blink slowly red on the transmitter. In this case repeat the bind-
ing process with at least 1 meter distance between transmitter
and receiver.
www.modellmarkt24.ch; www.modellmarkt24.de
To Next Page
Loading...
Need help?
General
