Section 7
122 Using Bluetooth
Setting Your Bluetooth Headset To Pairing Mode
The rst step in setting up any Bluetooth device is called “Pairing.” This step
is required because there are no wires to link your Jitterbug to your Bluetooth
device. “Pairing” happens when your Jitterbug and your Bluetooth device agree
to communicate with one another. By “Pairing,” your Jitterbug recognizes your
Bluetooth device and the two devices automatically accept communication from
each other.
For step-by-step instructions on setting your Bluetooth headset to pairing mode,
please refer to the instruction guide found in your Bluetooth headset packaging.
To Next Page
Loading...
