E-Smart Zone Controller
13
（
1
）
On/off
Press the on/off button to turn unit on or off.
When unit is turned off, mode, temperature, fan speed and swing can
’
t be set.
（
2
）
Mode setting
Press the Mode buttons to set unit
’
s operation mode.
Modes for indoor units of different series are not all the same. If a certain mode is
not available for the indoor unit, the icon of the corresponding mode cannot be
selected.
（
3
）
Temperature setting
Press the up or down buttons to adjust temperature. Each time pressing the button
will increase/decrease the temperature by 1
℃
/
℉
.
Touch the temperature value zone(figure
“
29
”
as shown in Fig. 3.1) can switch
to display
“
indoor temp
”
. The corresponding indoor temperature value will be
displayed.
（
4
）
Fan speed setting
Press fan speed button to set unit
＇
s fan speed.
Note: Unit defaults to low fan speed in dry mode. Fan speed cannot be set in dry
mode or floor heating mode.
（
5
）
Swing setting
Pressing the button
“
Left & Right
”
or
“
Up & Down
”
or can turn on or off the swing
function.
Note: Swing types for indoor units of different series are not all the same.
（
6
）
Malfunction view
When indoor unit fails to function well, press to view the information of
malfunctions.
3.2.2 Advanced Control Parameters
Press Advance Button to enter the advance page.
Press icon buttons to turn on or off the corresponding function.
（
1
）
Functions of Sleep, Quiet, Auto Quiet, E-Heater, Absence, Rapid and
Energy Saving can only be effective when unit is turned on.
（
2
）
When sleep function is on, quiet function will be turned on subsequently.
Sleep function will not be effective under auto, fan or floor heating mode.
To Next Page
Loading...
