23
Maintenance
Service Manual
Steps Procedure
7
8
9
Remove condenser and evaporator
Unsolder pipe connecting to aspiration/
discharge pipe. Then remove condenser
and evaporator. (Note: before unsoldering,
discharge refrigerant completely.
Remove electric box cover and electric box
Loosen 5 clasps between electric box cover
and electric box. Then remove electric box
cover. Then remove 2 connection screws
showing in g 2 and remove electric box
subsequently.
Remove water tray and water level switch
Remove 6 clasps between chassis and
water tray and then remove water tray.
Loosen clasps between water level switch
and water
tray. Then remove water level switch.
condenser
evaporator
electric box cover
water tray
water level switch
electric box
screws
clasps
clasps
To Next Page
Loading...
