Gree HNTF24/A-D

36
Condensing Unit
Service Manual
Disassemble of water-containing plate modules
Remark: Make sure the power supply is cut off before disassembling and protect all the parts during disassembly.
Step Illustration
Handling Instruction
Disassemble of water-
containing plate modules
●Remove the water-containing plate modules.
Disassembly of evaporator components
Remark: Make sure that the power supply is cut off and protect the copper tube and aluminum n. If the time for disassembly shall be long,
seal the copper tube .
Step Illustration Handling Instruction
Disassembly of evaporator
components
●Unscrew the 6 screws of evaporator, 3 screws
of water groove press board and the 2 screws
of water board to remove the evaporator.
Disassembly of xing plate sub-assy for air sweeping fans
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during disassembly.
Step Illustration Handling Instruction
Disassembly of xing plate
sub-assy for air sweeping
fans
●Remove the display board, mounting support
and mounting plate of swing motor in turn.
Disassembly of fan and motor components
Remark: Make sure that the power supply is cut off before disassembling and protect all the parts during disassembly, especially the
fastening screws for fans.
Step Illustration Handling Instruction
1. Disassembly of front and
back scroll cases
●Press the buckle at the joints of front and back
scroll cases with hands and pull upward to
remove the front scroll case. Then remove the
screws on the back scroll case. Lift the buckle
of back scroll case with hands and remove
it.(As is shown in the graph, circle represents 2
screws on left and right.)
2. Disassembly of fans
●Unscrew the 2 screws of coupling, take out
the rotating shaft and louver, then loosen the
tighten screw of louver to remove the louver
3. Disassembly of bearing
xing plates
●Unscrew the 3 screws and 2 nuts of support to
remove the mounting support.